Setting The Clock - Yamaha DRX-730 Mode D'emploi

Setting the clock

To display the time or program the timer, you must
first set the clock.
ENTER
TIMER
1
Press TIMER.
"Set Clock" appears on the display for a few
seconds, and then the message "Press and hold
ENTER key for 3 sec. " scrolls across the display.
P P P P r r r r e e e e s s s s s s s s a a a a n n n n d d d d h h h h o o o o l l l l d d d d
If the clock has already been set, "Clock Time" will
appear on the displayed for a few moments, then
the time will be displayed.
2
While the message is scrolling across the
display, press and hold down ENTER for 3
seconds until the hours display starts flashing.
0 0 0 0 0 0 0 0 : : : : 0 0 0 0 0 0 0 0
3
Use Up/Down ( / ) to set the hours.
The hours can be set from 0 to 12, AM or PM. On
some models, the default hours display uses the
24-hour clock.
4
Press Right ( ). The minutes display starts
flashing.
0 0 0 0 0 0 0 0 : : : : 0 0 0 0 0 0 0 0
5
Use Up/Down ( / ) to set the minutes.
Use Left/Right ( / ) to toggle between the hour
and minute displays if necessary.
TOP MENU MENU
PRESET
INFO.
A E ENTER A E
SETUP RETURN
VOLUME
MEMORY
AUTO/
MANUAL
TUNER
BAND
DVD/USB AUX/PORTABLE DOCK
SOUND PURE DIRECT MUTE
TIMER SLEEP DIMMER DISPLAY
Chapter 3: General Functions
6
Press ENTER.
The time is set and the display stops flashing.
Notes:
• To switch between 12- and 24-hour clock, while
the time is being displayed, use Left/Right ( / ).
• If the power cable is disconnected or there's a
power failure, the clock will continue working for
approximately 5 minutes. But beyond this, the
time setting will be cleared.
3
21
En