Table des Matières
Publicité
PROGRAMMING
"PROGRAMMING MODE MENU ITEMS" is displayed.
4. Press
two, (2) times. "PROGRAMMING MODE SYSTEM
SETUP" is displayed.
5. Press
eleven, (11) times. "CONTROL TYPE ELECTRIC (or
GAS)" is displayed. (type varies by grill).
6. Use
and
to change Control Type to match the
design of the grill.
7. Press
to save the changes.
8. Press
to return to "PROGRAMMING MODE MENU
ITEMS"
9. Press
again to exit.
To Turn Extended Time On/Off:
1. Press and hold
for three, (3) seconds. "ENTER CODE" is
displayed.
2. Using the Product buttons, 0-9 enter the code, (1251).
"ENTER CODE **** " is displayed.
3. Press
to enter the Programming Mode.
"PROGRAMMING MODE MENU ITEMS" is displayed.
4. Press
two, (2) times. "PROGRAMMING MODE SYSTEM
SETUP" is displayed.
5. Press
twelve, (12) times. "EXTENDED TIME NO (or YES)"
is displayed.
6. Use
and
to turn Extended Time on or off.
7. Press
to save the changes.
8. Press
to return to "PROGRAMMING MODE MENU
ITEMS"
9. Press
again to exit.
To Change the Grill Function:
1. Press and hold
for three, (3) seconds. "ENTER CODE" is
displayed.
2. Using the Product buttons, 0-9 enter the code, (1251).
"ENTER CODE **** " is displayed.
3. Press
to enter the Programming Mode.
"PROGRAMMING MODE MENU ITEMS" is displayed.
4. Press
two, (2) times. "PROGRAMMING MODE SYSTEM
SETUP" is displayed.
5. Press
thirteen, (13) times. "FUNCTION CLAMSHELL (or
FLAT)" is displayed.
6. Use
and
to toggle between Flat mode and
Part # 4517124 Rev. 7 (08/17/11)
continued
Clamshell mode.
7. Press
to save the changes.
8. Press
to return to "PROGRAMMING MODE MENU
ITEMS"
9. Press
again to exit.
To Change the Start Delay:
1. Press and hold
for three, (3) seconds. "ENTER CODE" is
displayed.
2. Using the Product buttons, 0-9 enter the code, (1251).
"ENTER CODE **** " is displayed.
3. Press
to enter the Programming Mode.
"PROGRAMMING MODE MENU ITEMS" is displayed.
4. Press
two, (2) times. "PROGRAMMING MODE SYSTEM
SETUP" is displayed.
5. Press
fourteen, (14) times. "START DELAY YES (or NO)" is
displayed.
6. Use
and
to turn Start Delay on or off.
7. If Start Delay is On (YES), press
XX:XX".
8. Use
and
to set the Delay Time to the desired value.
9. Press
to save the changes.
10. Press
to return to "PROGRAMMING MODE MENU
ITEMS"
11. Press
again to exit.
To Change the Alarm Mode:
1. Press and hold
for three, (3) seconds. "ENTER CODE" is
displayed.
2. Using the Product buttons, 0-9 enter the code, (1251).
"ENTER CODE **** " is displayed.
3. Press
to enter the Programming Mode.
"PROGRAMMING MODE MENU ITEMS" is displayed.
4. Press
two, (2) times. "PROGRAMMING MODE SYSTEM
SETUP" is displayed.
5. Press
fifteen, (15) times. "ALARM MODE AUTO (or
MANUAL)" is displayed.
6. Use
and
to change the Alarm Mode to either Auto
or Manual.
7. Press
to save the changes.
to display "DELAY TIME
Page 27
Publicité
Table des Matières
