Table des Matières
Publicité
CLEANING AND MAINTENANCE
13
• Rinse the edges of all three
platens.
• Press green button to raise
center platen.
17
• Wipe lower grill with a
clean,sanitizer-soaked
grill cloth. Repeat until no
visible soil remains.
PLATEN ZEROING
Turn Master power switch "ON", wait for controllers to display
"OFF".
Note: Release sheets should not be installed during this
procedure.
1. Press and hold
for three, (3) seconds. "ENTER CODE" is
displayed.
2. Using the Product buttons, 0-9 enter the code, (1251).
"ENTER CODE **** " is displayed.
Page 16
14
• Pour a small amount of
lukewarm water on a
clean, sanitizer-soaked
grill cloth over the
bottom grill surface and
wipe off residue.
18
• Empty, wash, rinse,
and replace the grease
troughs.
continued
15
• Place upper platen
release material sheets
fl at on the lower grill
surface.
• Gently clean both sides
of the release material
sheets with the grill
cleaning pad
19
• Wipe remaining grill
surfaces with a clean,
sanitizer-soaked grill
cloth.
3. Press
to enter the Programming Mode.
"PROGRAMMING MODE MENU ITEMS" is displayed.
4. Press
two, (2) times in succession to display
"PROGRAMMING MODE SYSTEM SETUP. "
5. Press
eight, (8) times. "PLATEN SET +/- XX" is displayed.
(XX=numbers that will vary from grill to grill.)
6. Allow time for grill to heat and turn ready. Press
both the Cancel (Green) and Standby (Black) buttons
simultaneously to lower the upper platen. Press the
16
• Rinse both sides of
the release material
sheets with a clean,
sanitizersoaked grill cloth.
• Reinstall the release
material sheets. Secure in
place with bars and clips
20
• Apply a thin coat of fresh
shortening to the lower
grill surface only..
Part # 4517124 Rev. 7 (08/17/11)
Publicité
Table des Matières
