Accessories - Garland XG24 Installation Et Fonctionnement

PLATEN ZEROING
Cancel (Green) button to raise the platen. Now, press both
the Cancel (Green) and (Black) Buttons to re-lower the
platen.
7. Remove platen adjuster caps from all four adjustment
points on each platen. Remove the four locking caps from
the adjustment points.
8. Using the adjusting tool lower platen until adjusting tool
touches the arm assembly.
9. With gapping tool, adjust right rear of platen until the
gapping tool fits snugly between the upper platen and
grill surface.
10. Move next to the left front adjuster and raise the platen
until the gapping tool fits snugly between the upper
platen and grill surface.

ACCESSORIES

Teflon Release Material Sheet - 1799303
(one per platen)
Part # 4517124 Rev. 7 (08/17/11)
11. Next go to the left rear adjuster and raise the platen until
the gapping tool fits snugly between the upper platen
and grill surface.
12. Move next to the right front adjustment and raise the
platen until the gapping tool fits snugly between the
upper platen and grill surface.
13. Repeat steps 9-12 one or more times until gapping tool
fits snugly between the upper platen and grill surface at
all four adjustment points without further adjustment.
(See diagram below.)
14. Replace the platen adjuster locking caps "hollow side
down" and tighten snugly. Replace platen adjuster caps.
15. Repeat steps 9-14 for each platen.
Teflon Release Material Rod - 4517008
(one per platen; 3 shown)
Teflon Release Material Clip - 1851301
(one per platen; 3 shown)
Page 17