Preparation - Worx WG771 Mode D'emploi

1.2 Preparation

a) Thoroughly inspect the area where the
equipment is to be used and remove all
stones, sticks, wires, bones, and other
foreign objects.
b) Do not operate the equipment when
barefoot or wearing sandals. Always
wear substantial footwear.
c) Disengage the self-propelled mechanism
or drive clutch on units so equipped
before starting the motor.
d) Never attempt to make a wheel height
adjustment while the motor is running.
e) Mow only in daylight or in good artificial
light.
f) Never operate the equipment on wet
grass. Always be sure of your footing.
Keep a firm hold on the handle and walk,
never run.
1.3 Operation
a) Do not put hands or feet near or
under rotating parts. Keep clear of the
discharge opening at all times.
b) Stop the blade(s) when crossing gravel
drives, walks, or roads.
c) After striking a foreign object, stop the
motor, unplug, thoroughly inspect the
mower for any damage, and repair the
damage before restarting and operating
the mower.
d) If the equipment should start to vibrate
abnormally, stop the motor and check
immediately for the cause. Vibration is
generally a warning of trouble.
e) Stop the motor and unplug whenever
you leave the equipment, before cleaning
the mower housing, and before making
any repairs or inspections.
f) Shut the motor off and wait until the
blade comes to a complete stop before
removing the grass catcher or before
unclogging the chute.
g) Mow across the face of slopes, never
up and down. Exercise extreme caution
when changing direction on slopes. Do
not mow excessively steep slopes.
h) Never operate the mower without proper
guards, plates, or other safety protective
devices in place.
i) Do not wash with a hose, avoid
3-in-1 Cordless Lawn Mower
getting water in motor and electrical
connections.
1.4 Maintenance
a) Check the blade and the engine
mounting bolts at frequent intervals for
proper tightness.
b) Keep all nuts, bolts, and screws tight to
be sure the equipment is in safe working
condition.
c) Check bag frequently for deterioration
and wear, and replace worn bags.
Check that replacement bags comply
with the original manufacturer's
recommendations or specifications.
d) Replace the blade if it is bent or cracked.
An unbalanced blade causes vibration
that could damage the motor drive unit
or cause personal injury.
e) Sharpen a dull blade equally at each end
to maintain the balance.
f) Clear the blade thoroughly and check
its balance by supporting it horizontally
on a thin nail through its center hole.
The nail should also be in a horizontal
position. If either end of the blade rotates
downward, remove some metal from
the heavy or lower end until the blade is
balanced. It is balanced when neither end
drops.
GENERAL SAFETY
WARNINGS FOR BATTERY
PACK
1) WARNING: Risk of fire and burns.
Do not disassemble, heat above
100°C (212°F), or incinerate. Do not
expose cells or batteries to heat or
fire. Avoid storage in direct sunlight.
2) Dispose of used battery promptly.
When disposing of secondary cells
or batteries, keep cells or batteries
of different electrochemical systems
separate from each other.
3) Keep battery out of reach of
children and in original package until
ready to use.
4) Never put batteries in mouth. If
13
EN