Worx WG771 Mode D'emploi page 18

STORAGE: (See Fig. L1,L2,L3)
Stop the mower and always remove the Safety Key. Clean the exterior of the machine
thoroughly using a soft brush and cloth. Do not use water, solvents or polishes. Remove all
grass and debris, especially from the ventilation slots.
Turn the machine on its side and clean the blade area. If grass cuttings are compacted in the
blade area, remove with a wooden or plastic implement.
Store the machine in a dry place. Do not place other objects on top of the machine.
To aid storage, release the handle release knobs (14), and rotate or fold the upper handle.
TROUBLESHOOTING
Problem
1. Mower doesn't run
when switch lever is
activated.
2. Motor stops while
mowing.
18
3. Mower runs but
cutting performance is
unsatisfactory, or does not
cut entire lawn.
4. Mower is too hard to
push.
5. Mower is abnormally
noisy and vibrates.
3-in-1 Cordless Lawn Mower
A. Check to make sure safety key has been installed and is fully
seated and that button on switch housing is being completely
pushed.
B. Release switch lever to turn mower off. Remove safety key,
turn mower over and check that blade is free to turn. If not free,
return to an authorized servicer. Blade should turn freely.
C. Has battery been fully charged? Plug in charger and wait for
green light to come on.
A. Release switch lever to turn mower off. Remove safety key, turn
mower over and check that blade is free to turn. If not free, return
to an authorized servicer. Blade should turn freely.
B. Raise cutting height of wheels to highest position and start
mower.
C. Has battery been fully charged? Plug in charger and wait for
green light to come on.
D. Avoid overloading the mower. Slow down the cutting pace by
pushing mower slower or raise the cut height. Or both.
A. Has battery been fully charged? Plug in charger and wait for
green light to come on. "
B. Release switch lever to turn mower off. Remove safety key.
Turn mower over and check: Blade for sharpness - Keep blade
sharp. Deck and discharge chute for clogging.
C. Wheel height adjustment may be set too low for grass
condition. Raise cutting height.
A. Raise cutting height to reduce deck drag on grass. Check
each wheel for free rotation.
A. Release switch lever to turn mower off. Remove safety
key. Turn mower on side and check blade to ensure it has not
been bent or damaged. If blade is damaged, replace with a
replacement blade. If the underside of the deck is damaged
return mower to an Authorized service center.
B. If there is no visible damage to the blade and the mower still
vibrates: Release switch lever to turn mower off, remove safety
key and remove blade. Rotate blade 180 degrees and retighten.
If mower still vibrates, return the mower to an authorized
service center.
Solution
EN