SOUNDMASTER SCD1800 Manuel D'instructions page 18

•
System
See under "SYSTEM SETTINGS".
1. Press repeatedly the "STANDBY / FUNCTION" button, until "CD" is shown in the display.
2. Open the CD compartment by pulling the CD door upwards by the tab.
3. Insert an audio CD with the printed side facing upwards on to the central cone so that the
CD clicks into place and then close the lid of the CD compartment.
4. The CD will start the playback from the first title.
5. In order to remove a CD, please press the "STOP / MENU" button, open the CD door and lift
the CD out carefully.
Keep always the CD deck closed.
NOTE:
If a disc is inserted with a wrong side face up, respectively if no disc is inserted, then the
message "NO DISC" appears in the display.
Control buttons:
➢ To start or interrupt the playback, press the "PLAY / PAUSE / CLOCK / ENTER" button.
➢ To stop the playback, press the "STOP / MENU" button.
➢ With "SKIP + / TUNING +" button you can jump to the next track.
If the button is kept pressed down, the machine starts to search forwards through the tracks.
The "SKIP - / TUNING -" button can be used as follows:
Press once = This starts the current track again from the beginning.
Press twice = This jumps back to the previous track.
If the button is kept pressed down, the machine starts to search backwards through the
tracks.
➢ To select a folder, press the "PRE - / FOLDER –" or "PRE + / FOLDER" button (only for
MP3-CD or USB).
Resume function
If you change the mode or turn off the unit and come back to the CD mode, the unit starts the
playback from the last point.
If you press the "STOP / MENU" button and start the playback again, the unit starts with the first
track (track 1).
Repeat function
During playback, press the repeatedly the "SCAN / PROG" button to select the following repeat
functions:
Audio CD:
Press once = the normal play mode. The display will show "Normal".
Press twice = the current track is repeated continuously. The display will show "Repeat One".
SCD1800 / English Instruction Manual
CD
5