LawnMaster GT1454 Manuel D'utilisation page 16

MAINTENANCE
WARNING
If the cutting lines protrude beyond the trimming blade, cut them off so that they
just reach the blade.
WINDING NEW LINE ONTO A SPOOL
1. You may wind new cutting lines onto an empty spool.
2. Replacement packs of cutting line are available from dealer.
3. Remove the empty spool from the grass trimmer as described above.
4. Remove any remaining cutting line from the spool.
5. Prepare 2 cutting lines ⑥ with the same length for winding. There are 4 eyelets ⑦ in the spool,
2 eyelets ⑦ in the upper section and 2 eyelets ⑦ in the lower section (Fig. 18).
6. First feed 4" of cutting lines ⑥ into the two eyelets ⑦. Two eyelets ⑦ should be in the different
sections of spool.
7. Wind the cutting lines ⑥ onto the spool in the direction of the arrow showed on spool. Make sure
to wind the lines on neatly and in layers. Do not crisscross (Fig. 19).
8. After winding, fix the end of lines ⑥ in the parking slot of the spool (Fig. 20).
9. If you want to use, operate as described above to fix the spool on the grass trimmer. Do not
forget to release the cutting lines ⑥ from the parking slot.
⑦ ⑦
WARNING
Only use the appropriate type of cutting line (0.065" round monofilament).
⑥
Fig. 18 Fig. 19
16
⑥
Fig. 20