L-Acoustics Coaxiale XT Serie Mode D'emploi page 4

Procédures d'accrochage
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

XT
COAXIAL RANGE -
rigging procedures
VERSION 2.0
!
7.
Suspension points
It is the user's responsibility to ensure that the Working Load Limit (WLL) of the suspension
points and/or chain hoists is greater than the total weight of the loudspeaker assembly in use.
WARNING
!
8.
System load capacity and setup safety limits
Load capacity and setup safety limits when flying or stacking a loudspeaker assembly should be
strictly followed according to the instructions outlined in this manual.
WARNING
!
9.
Local regulations
Some countries require higher Ultimate Strength Safety Factors and specific rigging approvals.
It is the user's responsibility to ensure that any overhead suspension of L-ACOUSTICS
systems has been made in accordance with all applicable local regulations.
As a general rule, L-ACOUSTICS
WARNING
!
10. Flying a loudspeaker
Always ensure that nobody is standing underneath the loudspeaker assembly when it is being
raised. As the system is being raised check each individual component to make sure that it is
securely fastened to the component above. Never leave the system unattended during the
installation process.
WARNING
11. Ground stacking a loudspeaker
!
Do not ground stack the system on uneven ground or platform.
If the system is ground stacked on a structure, platform, or stage. ALWAYS check that this last
can support the total weight of the system.
Secure the system to the structure, platform, or stage using ratchet straps or any other
WARNING
applicable devices.
!
12. Dynamic load
When a loudspeaker assembly is deployed in an open air environment, wind effect should be
taken into account. Wind can produce dynamic stress to the rigging components and
suspension points. If the wind force exceeds 6 bft (Beaufort scale) it is highly recommended to
lower down and/or secure the loudspeaker assembly.
WARNING
!
13.
Manual
Keep this manual in a safe place during the product lifetime. This manual forms an integral part
of the product. Reselling of the product is only possible if this manual is available. Any changes
made to the product have to be documented in writing and passed on to the buyer in the event
of resale.
IMPORTANT
XT-P_RM_ML_2.0
P
SELF-POWERED COAXIAL RANGE
®
recommends the use of safety steel at all times.
w w w . l - a c o u s t i c s . c o m
®
2 en

Publicité

Chapitres

Table des Matières
loading

Table des Matières