Disassembling Procedure - L-Acoustics Coaxiale XT Serie Mode D'emploi

Procédures d'accrochage
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

4.
Select the desired enclosure's orientation (in 10° steps) and secure the ball locking pin to the enclosure through
the U-bracket's pivoting arm.
!
Verify that the ball locking pin is correctly secured to the enclosure by pulling on it and
that the enclosure cannot rotate freely.
WARNING
10° steps angle
L-ACOUSTICS
!
A safety eyebolt accessory can be added using the M8* insert located on the rear face of the
115XT HiQ enclosure (see Figure 23).
WARNING
* The "M8" notation refers to the European standard (please see applicable external documentation).
6.3.2

Disassembling procedure

The disassembling procedure is the exact reversed sequence of the assembling procedure.
XT-P_RM_ML_2.0
selection
Figure 17: Selecting the angle
recommends using an additional safety point when rigging enclosures.
®
w w w . l - a c o u s t i c s . c o m
EN
19 en

Publicité

Chapitres

Table des Matières
loading

Table des Matières