Rigging The 115Xt Hiq Enclosure With The Etr15; Assembling Procedure - L-Acoustics Coaxiale XT Serie Mode D'emploi

XT
COAXIAL RANGE -
rigging procedures
VERSION 2.0
6.3

Rigging the 115XT HiQ enclosure with the ETR15

6.3.1

Assembling procedure

!
All along the assembling procedure, strictly follow the sequence of the successive steps.
WARNING
1. Fix the ETR15 U-bracket to a ceiling, wall, or structure as described in the section 5.3.
Note: Wall-mounting can be performed either in the vertical or horizontal orientation.
!
ALWAYS position the fixed arm on the bottom when wall-mounting the U-bracket in the
vertical orientation.
WARNING
2. Open the U-bracket's pivoting arm as described
below:
a. Remove the ball locking pin from the pivoting
arm.
b. Pull on the spring-loaded safety and open the
pivoting arm.
3. Fix the 115XT HiQ enclosure to the U-bracket as
described below:
a. Insert an enclosure's pole socket into the
stud located on the U-bracket's fixed arm.
b. Rotate the pivoting arm back into position:
the spring-loaded safety should lock
automatically.
Verify that the pivoting arm is
!
correctly secured by checking that
it cannot move freely and that the
spring-loaded safety is fully engaged
in locking position.
WARNING
XT-P_RM_ML_2.0
P
SELF-POWERED COAXIAL RANGE
a.
b.
Figure 15: Opening the pivoting arm
b.
Figure 16: Securing enclosure to the ETR15
w w w . l - a c o u s t i c s . c o m
b.
a.
18 en