Installation; Rigging The 8Xt Or 108P Enclosure With The Etr8-2; Assembling Procedure - L-Acoustics Coaxiale XT Serie Mode D'emploi

XT
COAXIAL RANGE -
rigging procedures
VERSION 2.0

6 INSTALLATION

6.1

Rigging the 8XT or 108P enclosure with the ETR8-2

6.1.1

Assembling procedure

!
All along the assembling procedure, strictly follow the sequence of the successive steps.
WARNING
1. Fix the ETR8-2 U-bracket to a ceiling, wall, or structure as described in the section 5.1.
Note: Wall-mounting can be performed either in the vertical or horizontal orientation.
!
ALWAYS position the fixed arm on the bottom when wall-mounting the U-bracket in the
vertical orientation.
WARNING
2. Remove the protecting screw from the top side of
the 8XT or 108P enclosure (5 mm hex key).
Note: Put the screw in a safe place as it should be
put back in place when disassembling.
3. Remove the safety pin from the U-bracket and open
the pivoting arm.
XT-P_RM_ML_2.0
P
SELF-POWERED COAXIAL RANGE
Protecting screw
w w w . l - a c o u s t i c s . c o m
Figure 9: Protecting screw
Figure 10: Opening the pivoting arm
14 en