Philips Azur Freemotion Mode D'emploi page 9

Note: Repeat the Calc-Clean process if the water that comes out of the iron
still contains scale particles.
After the Calc-Clean process
Put the iron on the base. Let the iron heat up to dry the soleplate.
1
Take the iron from the base when the light ring turns steady blue.
2
Move the iron gently over a piece of cloth to remove any water
3
stains on the soleplate.
Storage
Set the steam control back to
1
Pour out any remaining water from the water tank.
2
Unplug the mains cord and wind the mains cord around the base.
3
(Fig. 16)
Remove iron from the base when you wind the cord, as the soleplate
could still be hot.
Put the iron on the base. Lock the iron to its base. (Fig. 17)
4
Let the iron cool down before you store it.
5
You can carry the iron and base by the iron handle. (Fig. 18)
Troubleshooting
This chapter summarises the most common problems you could
encounter with the appliance. If you are unable to solve the problem
with the information below, visit www.philips.com/support for a list of
frequently asked questions or contact the Consumer Care Centre in
your country (see the worldwide guarantee leaflet for contact details).
Problem
The iron does
not produce
steam.
. (Fig. 2)
Possible cause
Cordless iron cools
down after a while. It
needs to be recharged.
ENGLISH
Solution
Put the iron back to the
base until the light ring
turns steady blue light,
indicating that the iron is
ready for use again.
11