Bridge Function; Residual Heat - BORETTI CRG916 Notice D'utilisation

6.6.5 Bridge function

This function "bridges" the two right-hand radiant elements (front
and back) into a single cooking zone controlled only by the second
knob on the right. The Booster function cannot be used when the
Bridge function is active.
Simultaneously turn the last two
knobs on the right clockwise
(beyond power level "9" until they
click and a beep is emitted) until
position "P" and hold them in this
position for at least 2 seconds (the
corresponding displays show the
adjacent symbols signalling the
function is active). Turn the second knob on the right to the desired
power level.
If a pan is removed from the radiant elements during cooking and not replaced
within 10 minutes, the function automatically deactivates.
To deactivate the function manually, return the knobs to "off" position.

6.6.6 Residual heat

After cooking is finished and the knob is returned to "off" position, the radiant
element's display shows the adjacent symbol alternated with the value ,
indicating that that radiant element has just been used and is still hot.
The symbol will flash for a few seconds, then will become steady and will
stay on until the glass temperature has gone below the safety level.
6.6.7 Ventilation
The cooling system is fully automatic. The cooling fan starts with a low speed
when the calories brought out by the electronic system reach a certain level.
The ventilation starts his high speed when the hob is intensively used. The
cooling fan reduces his speed and stops automatically when the electronic
circuit is cooled enough.
44