Pan Recognition - BORETTI CRG916 Notice D'utilisation

6.5 Pan recognition

an electronic sensor detects if a pan is present or absent on the
radiant element. If the type of pan is unsuitable for magnetic
induction cooking (see section "6.5") or if the pan is too small
(see table "MINIMUM DIAMETER" the adjacent symbol is displayed.
If during cooking a pan is removed from the radiant element without having first
returned the relative knob to "0" position, the power value, previously set and
shown on the relative display, will be automatically replaced with the symbol
.
If the pan is repositioned correctly on the radiant element, the symbol
switches off and cooking will resume normally; otherwise, after 10 minutes, the
symbol will switch off, the knob will have to be returned to "0" position and a
new power value set before the radiant element can be used again.
If a knob is turned to any position before placing a pan on the radiant element,
the relative display shows the set power value and then immediately replaces
it with the symbol
meantime a pan is placed correctly on the radiant element, cooking will begin;
otherwise the radiant element does not activate and symbol
reactivate the radiant element, the relative knob must be returned to "0" position
and a new power value set.
Pan recognition limits: the diameter of the pan base is signalled by a
circumference or perimeter on the cooking zone.
DIAMETER MINIMUM
(MM)
DIAMETER MAXIMUM
(MM)
(the radiant element stands by for 10 minutes). If in the
1
145
200
40
switches off. To
2 3
180 145
230 220