Electric Connection - BORETTI CRG916 Notice D'utilisation

3.3 Electric Connection

Make sure that the voltage and capacity of the power line conform to the data
shown on the plate located on the back of the appliance; a copy is attached to
the manual. A second plate, including detailed information about the model and
serial number, is placed inside the equipment on the left side and is visible on
opening the oven door. These plates must never be removed.
Prepare an omni-polar cut-off device on the power supply line of the appliance
with a contact opening distance equal to or more than 3 mm, located in a
convenient position near the appliance.
Note:
Do not use reducers, adapters or shunts.
Before making the electric connection, make sure of the efficiency of the
earthing. Make sure that the relief valve and the home wiring system are able to
withstand the appliance load. The yellow/green earth cable must not be subject
to cut-offs. The electric cable must not come into contact with parts whose
temperature is more than 50°C higher than room temperature.
14