Important - BORETTI CRG916 Notice D'utilisation

It is possible to connect the gas in the following ways:
* using iron or copper rigid pipe;
* using uninterrupted stainless steel flexible pipe with a mechanical fitting
conforming to standards regulation norm (maximum length of extended
pipe 2000 mm). The pipe should be connected straight to the elbow of the
ramp;
* by inserting a flexible rubber pipe conforming to regulation norm in force.
This pipe should be coupled straight to the rubber-holder P corresponding
to the gas used, and locked with a clamp F conforming to standards
regulations in force. In the latter case, check the expiry date printed on the
pipe and replace it before that date.
LIQUID GAS
Using flexible rubber pipes with a max. length of 1500 mm:
* do not allow the pipes to be constricted or crushed;
* pipes must not be subject to tractive force or torsional stress;
* do not allow the pipes to come into contact with cutting or sharp edges,
etc...
* do not allow the pipes to come into contact with parts that can reach
temperatures of 70°C above room temperature;
* make sure the entire length of the pipes can be inspected;
* do not use the Natural Gas Regulator supplied with the appliance for
Propane Gas.

Important:

In Belgium, in accordance with Belgian standards NBN D 51-003 and NBN
D 51-006, the type of connection with elastomer hose (Flexible rubber pipe)
is prohibited for cookers installed inside buildings.
METHANE GAS
20