Precautions For Use - Teac MC-D800 Mode D'emploi

Precautions for use

o Do not place anything on the turntable cover .
Objects on the cover might cause noise due to vibra-
tions or fall off, especially during playback .
o Avoid placing the unit in direct sunlight, close to
a source of heat or in other similar conditions . Do
not place the unit on top of an amplifier or other
equipment that might generate heat that exceeds
the operating temperature range of this unit .
Doing so could cause discoloration, deformation or
malfunction .
o As the unit could become warm during operation,
always leave sufficient space around it for ventila-
tion . When installing this unit, leave at least 20 cm
(8") between it and walls . To allow good heat dis-
sipation, leave a little space between it and other
devices . When placing it in a rack, for example, leave
at least 40 cm (16") open above it and 10 cm (4")
open behind it . Failure to provide these gaps could
cause heat to build up inside and result in fire .
o DO NOT MOVE THE UNIT DURING PLAYBACK . During
playback, the disc or the record rotates . Do not lift or
move the unit during playback . Doing so may dam-
age the disc, the record, the stylus, the cartridge or
the unit .
o Always remove the disc or the record before relocat-
ing or moving this unit . Moving the unit with a disc
inside or a record on the turntable could damage the
disc, the record, the stylus and the cartridge or could
cause a malfunction .
o The voltage supplied to the unit should match the
voltage as printed on the rear panel . If you are in any
doubt regarding this matter, consult an electrician .
o Do not open the cabinet as this might result in dam-
age to the circuitry or electrical shock . If a foreign
object should get into the unit, contact your dealer .
o When removing the power plug from the wall outlet,
always pull directly on the plug, never yank on the
cord .
o If a TV is turned on while the unit is on, static might
appear on the TV screen depending on the charac-
teristics of the TV broadcast signal . If this occurs, put
this unit into standby mode (off ) when using the TV .
Maintenance
If the surface of the unit gets dirty, wipe it with a soft
cloth or use diluted mild liquid soap . Allow the surface
of the unit to dry completely before using .
Do not use chemical cleaning cloths, thinner or similar
substances as they could damage the surface of the
unit .
V CAUTION
For safety, disconnect the power cord from
the socket before cleaning.
9