Storage Precautions; Handling Precautions - Teac MC-D800 Mode D'emploi

Masquer les pouces Voir aussi pour MC-D800:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 64
Precautions for use
o Do not use cracked discs because they could dam-
age the unit .
o When writing something on the label side of a disc,
use a felt tip permanent marker . The use of a ball-
point pen or other pen with a hard tip could damage
the disc, making it unplayable .
o Never use commercially available CD stabilizers .
Doing so could make the disc unplayable or damage
the unit .
o Never use CDs with irregular shapes, including heart-
shaped and octagonal discs because such discs
could damage the unit .

Handling precautions

o Always insert the disc into the disc tray with the label
side up .
o If the side of the disc that the signal is recorded on
(unlabeled side) has scratches, fingerprints or dirt on
it, for example, playback errors could occur . Please
handle discs with care .
o To remove a disc from its case, press down on the
center of the case and hold the disc by its edges .
Do not touch the side of the disc that has the data
encoded on it (unlabeled side) .
Removal from case
Holding by edges

Storage precautions

o Discs should be stored in their cases when not being
used . Failure to do so could result in warping and
scratches .
o Do not leave discs in places that are exposed to direct
sunlight or that are very humid or hot . Long exposure
to such conditions could warp or degrade discs, mak-
ing them unplayable .
o Since CD-R/CD-RW discs are more susceptible to the
effects of heat and ultraviolet rays compared to com-
mercial CDs, do not leave them for long periods of
time in places that are, for example, exposed to direct
sunlight or near equipment that generate heat .
o Smudges on a disc might cause the sound to skip or
degrade the sound quality . Always clean discs before
storing them .
Maintenance
o If the side of the disc that has the data encoded on
it (unlabeled side) becomes dirty with fingerprints
or dust, use a soft cloth to wipe the surface from the
center directly toward the edge .
o Never use record cleaners, antistatic treatments,
thinners or similar chemicals to clean discs . Such
chemicals could harm the surface of the disc .
11

Publicité

Table des Matières
loading

Table des Matières