Operating Elements And Connections; Safety Notes; Applications - IMG STAGELINE PARL-183RGB Mode D'emploi

All operating
GB
described can be found on the fold-out page 3.
1 Operating Elements
and Connections
1 Buttons to select the operating mode and to
change adjustments, see fig. 2
2 Display
3 Locking screws for the mounting/set-up brack-
ets
4 Mounting / set-up brackets
5 M8 threaded jack
6 Microphone for music control
7 XLR chassis mount plug DMX IN: DMX signal
input for connection of a controller or to the DMX
signal output of another spotlight
pin 1 = ground, pin 2 = DMX-, pin 3 = DMX+
8 XLR jack DMX OUT: DMX signal output for con-
nection to the DMX input of another spotlight;
pin 1 = ground, pin 2 = DMX-, pin 3 = DMX+
9 Support for the mains fuse
Only replace a blown fuse by one of the same
type.
10 Mains jack for connection to a socket (230 V~ /
50 Hz) via the supplied mains cable

2 Safety Notes

The unit corresponds to all required directives of
the EU and is therefore marked with
WARNING The unit uses hazardous mains volt-
age. Leave servicing to skilled per-
sonnel only and do not insert any-
thing into the air vents; inexpert
handling may result in electric shock.
Please observe the following items in any case:
G
The unit is suitable for indoor use only. Protect it
against dripping water and splash water, high air
humidity, and heat (admissible ambient tempera-
ture range 0 – 40 °C).
G
Do not operate the unit or immediately discon-
nect the mains plug from the mains socket
1. if the unit or the mains cable is visibly dam-
aged,
2. if a defect might have occurred after the unit
was dropped or suffered a similar accident,
3. if malfunctions occur.
In any case the unit must be repaired by skilled
personnel.
8
elements and connections
.
G
Never pull the mains cable for disconnecting the
mains plug from the socket, always seize the
plug.
G
No guarantee claims for the unit and no liability
for any resulting personal damage or material
damage will be accepted if the unit is used for
other purposes than originally intended, if it is not
safely mounted or not correctly operated, or if it is
not repaired in an expert way.
G
Important for U. K. Customers!
The wires in this mains lead are coloured in ac -
cord ance with the following code:
green/yellow = earth
blue = neutral
brown = live
As the colours of the wires in the mains lead of
this appliance may not correspond with the
coloured markings identifying the terminals in
your plug, proceed as follows:
1. The wire which is coloured green and yellow
must be connected to the terminal in the plug
which is marked with the letter E or by the earth
symbol , or coloured green or green and yel-
low.
2. The wire which is coloured blue must be con-
nected to the terminal which is marked with the
letter N or coloured black.
3. The wire which is coloured brown must be con-
nected to the terminal which is marked with the
letter L or coloured red.
Warning – This appliance must be earthed.
If the unit is to be put out of operation
definitively, take it to a local recycling plant
for a disposal which is not harmful to the
environment.

3 Applications

This LED spotlight serves for effect illumination
e. g. on stage, in discotheques, and festival rooms.
As a light source, extra bright LEDs are used which
have a low power consumption, a low heat devel-
opment and a long life. The LEDs allow to radiate
coloured light in the three primary colours (red,
green and blue) and light which can be mixed from
the primary colours by addition. Besides, strobo-
scopic effects and colour transitions are possible.
The spotlight is designed for control via a DMX
controller (6 DMX control channels). However, it
can also be operated without controller. For this
purpose various functions are available (colour
spotlight, colour transitions, stroboscope, music
control).