Control Station - LiftMaster Logic 5.0 GSD Mode D'emploi

CONTROL STATION

To prevent possible SERIOUS INJURY or DEATH from
electrocution:
• Be sure power is NOT connected BEFORE installing door
control.
To prevent possible SERIOUS INJURY or DEATH from a closing
door:
• Install door control within sight of door, out of reach of
children at minimum height of 5 feet (1.5 m) above floors,
landings, steps, or any other adjacent walking surface, and
away from ALL moving parts of door.
• Install the control station far enough from the door to prevent
the user from coming in contact with the door while operating
the controls.
NOTE: The low voltage control circuit wiring requires insulated, 20
AWG or greater wire. Refer to back page for additional control
wiring.
1
Remove the control station cover.
Fasten the control station to the wall at least 5 feet above
2
floors, landings, steps, or any other adjacent walking
surface. The installation surface must be smooth and flat.
Attach the MAS label to the side of the control station.
3
5' (1.5 m)
5
Wiring
1
^
O P
E N
O
S T
O P
2
UL Entrapment Placard
MAS Label
• Install the entrapment warning placard on wall next to the
control station in a prominent location that is visible from the
door.
• NEVER permit children to operate or play with door control
push buttons or remote controls.
• Activate door ONLY when it can be seen clearly, is properly
adjusted and there are no obstructions to door travel.
• ALWAYS keep door in sight until completely closed. NEVER
permit anyone to cross path of closing door.
3
Select appropriate knockout and run the wires to the
operator.
Connect wires to the control station and replace the control
4
station cover.
5
Fasten the entrapment warning placard next to the control
station.
4
11
LED
3-Button
Station
Maintenance
Alert LED
(RD) (WH)
Open
Close
Stop