AVS Electronics OUTSPIDER PA Mode D'emploi page 52

Infrared and Microwave concatenated signals
Œ
E
Synoptic panel
N
Access to this menu require a choice in type of connection:
G
1- Follow the procedure based on the the type of connection to be carried out.
NOTE: if it is a USB connection, it may require installation of drivers for recognising the peripheral device. If the drivers are not recognised automatically, it
is necessary to specify the following file path to the operating system C:\Programmi\Xwin\Driver\ and select the stmcdcAVS.inf file.
2- Select the address of the sensor or the satellite on HPWIN and then chose "Connect".
NOTE: If connected to a sensor by way of USB, it displays the status in real time, if connected by way of XSATHP satellite, it displays the status of all active
sensors connected to the actual satellite.
Elements displayed:
Sensor address (not managed with a USB connection)
w
Sensor date and time settings
w
Power supply voltage
w
Sensor temperature
w
Sensor status: OutSpider PA and PA WS(UB)(U): Tamper-Alarm - Antimask
w
OutSpider DT and DT WS(UB)(U): Tamper-General alarm-
•
Antimask-Microwave section alarm
Œ
Both the infrared and the microwave section detect a slight background
noise that is not sufficient to generate an alarm.
•
Both section detect a movements that is useful to generate an alarm.
Outspider PA and
Outspider PA WS(UB)(U)
- 52 -
.
Outspider DT and
Outspider DT WS(UB)(U)