Hitachi NT 65MA4 Manuel D'instructions Et De Sécurité page 13

□ The push lever and trigger must move
smoothly.
Trigger
Push
Lever
(2) Adjust the air pressure to 70 psi (4.9 bar 5
kgf/cm ).
2
Connect the air hose.
Do not load any nails in the Nailer.
Set the switching device to the upward
position (SINGLE
ACTUATION MECHANISM).
(Set the switching device to the upward
position completely as shown in the
diagram. Otherwise, it will not operate
properly.)
□ The nailer must not leak air.
Do not connect
air hose
SEQUENTIAL
Upward position
Switching Device
(3) Remove the fi nger from the trigger and
press the push lever against the wood.
□ The nailer must not operate.
Depress
Push
Lever
(4) Separate the push lever from the wood.
Next, point the nailer downward, pull the
trigger and then wait in that position for 5
seconds or longer.
□ The nailer must not operate.
(5) 1 Without touching the trigger, depress
the push lever against the workpiece.
Pull the trigger.
□ The nailer must operate.
2 Remove the fi nger from the trigger.
□ Nailer operation will end (the driver
blade will return to the top).
English
Do not pull Trigger
Pull Trigger
13