Connection - JVC KD-R951BT Manuel D'instructions

Wiring connection
KD-R951BT KD-R852BT / KD-R851BT
Rear output
Front output
Subwoofer output
To the steering wheel
remote control adapter
For some VW/Audi or Opel (Vauxhall)
automobiles
You may need to modify the wiring of the
supplied power cord (D) as illustrated.
If the unit does not turn on with modified
wiring 1, use modified wiring 2 instead.
Y: Yellow R: Red
Original wiring
Modified wiring 1
( or )
Modified wiring 2
Signal cord
(not supplied)
Rear/subwoofer output
Antenna terminal
Light blue/yellow
STEERING
WHEEL
REMOTE
If your car does NOT have an ISO
terminal
* Custom wiring harness (separately
purchased)
IMPORTANT: A custom wiring harness
(separately purchased) which is suitable for
your car is recommended for connection.
Remote wire
(not supplied)
To Blue/white wire of
the wiring harness (D)
JVC Amplifier
Fuse (10 A)
Microphone input jack ( 9)
ISO connector
Pin Color and function
A4 Yellow : Battery
A5 Blue/White : Power control
A6 Orange/white : Car light control switch
A7 Red : Ignition (ACC)
A8 Black : Earth (ground) connection
B1 Purple ª
: Rear speaker (right)
B2 Purple/black
·
B3 Gray
ª
: Front speaker (right)
B4 Gray/black
·
B5 White
ª
: Front speaker (left)
B6 White/black ·
B7 Green
ª
: Rear speaker (left)
B8 Green/black
·
Part list for
installation
(A) Faceplate
(B) Trim plate
(C) Mounting sleeve
(D) Wiring harness
(E) Extraction key
ENGLISH | 21