Bluetooth - JVC KD-R951BT Manuel D'instructions

BLUETOOTH®
You can operate Bluetooth devices using this
unit.
Connect the microphone
Rear panel
Microphone input jack
Adjust the
microphone angle
Secure using cord clamps (not
supplied) if necessary.
If you turn off the unit or detach the control
panel during a phone call conversation,
the Bluetooth connection is disconnected.
Continue the conversation using your mobile
phone.
Supported Bluetooth profiles
– Hands-Free Profile (HFP1.5)
– Advanced Audio Distribution Profile (A2DP)
– Audio/Video Remote Control Profile
(AVRCP1.3)
– Object Push Profile (OPP)
– Phonebook Access Profile (PBAP)
– Serial Port Profile (SPP)
Pair a Bluetooth device
When connecting a Bluetooth device to the
unit for the first time, perform pairing between
the unit and the device. Once the pairing is
completed, the Bluetooth device will remain
registered in the unit even if you reset the unit.
Microphone
• Up to five devices can be registered (paired)
(supplied)
in total.
• A maximum of two Bluetooth phones and
one Bluetooth audio device can be connected
at any time.
• This unit supports Secure Simple Pairing (SSP).
• Some Bluetooth devices may not
automatically connect to the unit after
pairing. Connect the device to the unit
manually. Refer to the instruction manual of
the Bluetooth device for more information.
1 Press B /SOURCE to turn on the unit.
2 Search and select "JVC UNIT" on the
Bluetooth device.
"BT PAIRING" flashes on the display.
• For some Bluetooth devices, you may
need to enter the Personal Identification
Number (PIN) code immediately after
searching.
3 Perform (A) or (B) depending on what
scrolls on the display.
• For some Bluetooth devices, pairing
sequence may vary from the steps
described below.
(A)
"[Device Name]"
"VOL – YES"
• "XXXXXX" is a 6-digit passkey randomly
generated during each pairing.
"XXXXXX"
"BACK – NO"
Ensure that the passkey which appears
on the unit and Bluetooth device is the
same.
Press the volume knob to confirm the
passkey.
Operate the Bluetooth device to confirm
the passkey.
(B)
"[Device Name]" "VOL – YES"
"BACK – NO"
Press the volume knob to start pairing.
• If "PAIRING" "PIN 0000" scrolls on
the display, enter the PIN code "0000"
into the Bluetooth device.
You can change to a desired PIN code
before pairing. ( 13)
• If only "PAIRING" appears, operate the
Bluetooth device to confirm pairing.
"PAIRING COMPLETED" appears when pairing
is completed.
• " " or " " will light up when a Bluetooth
mobile phone is connected.
• " " will light up when a Bluetooth audio
player is connected.
Bluetooth compatibility check mode
You can check the connectivity of the
supported profile between the Bluetooth
device and the unit.
• Make sure there is no Bluetooth device
connected.
1
Press and hold .

"BLUETOOTH"

"CHECK MODE" appears.
"SEARCH NOW USING PHONE"
0000" scrolls on the display.
"PIN IS
ENGLISH | 9