Cut To Edge; Working Time; How Efficiently Will My Landroid; Mow The Grass - Worx LANDROID Mode D'emploi

E1

5.3 Cut to edge

Off-centered Blade Turning Disc (13) design, it provides a clean cut
with narrowest distance to the boundary or wall, it helps to minimize
the amount and frequency of manual trimming along the uncut area.
Additionally, the design with an underneath protective cover keeps
any object away from touching the turning blades in case of injury. (See
Fig. F)

5.4 Working time

The default daily working schedule is set for the first 8 hours for
mowing and next 16 hours for standby on the charging bay, see
below. The working schedule can be re-set by using mobile apps
(Only for specific model, please check Technical Data & Declaration of
Conformity), for downloading the app, please refer to Remote Mobile Control.
Mowing Standby
8h 16h
Day 1

5.5 How efficiently will my Landroid

Mowing times are different for every lawn depending on the factors mentioned below. Gradually adjust the time you allow
®
your Landroid to mow each day until you find the most suitable setting.
®
Your Landroid is capable of mowing areas of different sizes, although this depends on various factors, such as:
• Species of grass in your lawn and its growth rate
• Sharpness of the Cutting Blades (12)
• Humidity
• Surrounding temperature
• Amount of obstacles in your Lawn
Unlike the most other mowers, Landroid
system, which is able to cut the much surrounding grass as possible.
Additionally, the holes on the bottom of the charging base allow the
grass growing through which makes elegant appearance.
®
The Landroid 's cutting height can be adjusted between 2cm-6cm.
Before starting your Landroid
grass to the height no more than 9 cm. Then make sure you set the
cutting height to its maximum cutting height of 6cm. (See Fig. G)
®
Your Landroid will cut its best in dry weather. It does not like wet
grass, which can build up on the Blade Turning Disc (13) and within
Lawn Mowing Robot
Mowing Standby
8h 16h
Day 2
®
uses side charging
®
for the first time, you should cut the
E2
"Cut to Edge" Tech
F
Mowing Standby
8h 16h
Day 3
®

mow the grass?

G
11
EN