Fault Symptoms - Worx LANDROID Mode D'emploi

13. Fault symptoms

®
If your Landroid does not work correctly, follow the trouble shooting guide below. If the fault persists, contact your Dealer.
Symptom
®
Landroid turns on, but the Blade
Disc does not move.
®
Landroid vibrates.
Grass is being cut unevenly.
The LED light on the Charging
Station does not turn on.
Green light flashing on charging
base.
®
Your Landroid is inside its
territory and the boundary wire
is connected. The error indication
light flashes red.
The charging time is far more
than 2h.
The mower does not charge.
®
Landroid is starting to have
shorter run-times between
charges.
Lawn Mowing Robot
Cause
®
Landroid is searching for the Charging
Base (except that you press the HOME
button to make it go to the charging
base, or the "Enable boundary cut"
function is operating).
Blades may be damaged. Check
condition of the Blade Disc.
®
Landroid does not work enough hours
per day.
Mowing area is too big.
Blades are dull.
The cutting height is set too low for the
length of the grass.
Grass or other object has wrapped
around the blade disc.
There is a build-up of grass in the Blade
Disc or Motor Frame Box.
There is no power.
The Boundary Wire isn't connected.
The boundary wire ends are clamped
incorrectly.
Poor connection caused by debris on
the Charging Strip.
The charging protection program has
activated due to high temperature.
There is no power.
Does not operate correctly while
manually charging.
Something is clogged in the Blade
Disc.
®
Landroid is shaking heavily.
The battery may be exhausted or old.
Action
®
This is normal, Landroid needs to recharge,
the Blade Disc does not rotate while it is
searching for the Charging Base automatically.
Check the Blades, and replace them if damaged.
Remove debris and foreign objects from the
blades and blade disc.
Add more hours to the mowing time.
Try decreasing the size of the mowing area or
adding more hours to the mowing time.
Change all the Blades and screws in order to
balance the Bade Disc.
Raise the cutting height and then gradually
lower.
Check the Blade Disc and remove the grass
or other object.
Make sure the Blade Disc rotates easily. If
need be, you may take off the Blade Disc and
then remove the debris.
Check the power cord is connected properly
to the charger and the charger is connected
to a suitable power supply.
Check that the Boundary Wire has been
connected correctly to the charging base.
Check there are no breaks in the boundary
wire.
Reverse the boundary wire ends.
Clean the Contact Pins located on the
Charging Base and the Charging Strip on
®
Landroid using a cloth.
Place the charging base in a shady area or
wait until the temperature has cooled down.
Check the power cord is connected properly
to the charger and the charger is connected
to a suitable power supply.
Refer to manual charging.
Take off the Blade Disc and clean it
The grass is too high and too thick.
Check the blade disc and blades, remove
debris and foreign objects from the blades
and blade disc.
Replace battery.
19
EN