Working With The Unit; Switching On The Device; Setting The Timer - IKA mini G Mode D'emploi

The AC adapter is suitable for 100 V to 240 V. The plug
adapter for the relevant country must be attached before
the AC adapter is plugged into the mains socket.
The software version appears briefly on the display, fol-
lowed by the display test, then an acoustic signal sounds.
Finally a red dot appears at the bottom right of the display
(stand-by display).

Switching on the device:

Press the "Power" button (item H) to switch the device on.
If the "Power" button (item H) had been used to switch
the device into stand-by mode, the previous timer value
setting is displayed.

Setting the timer:

Before the centrifuge can be started by pressing the "Start/
Stop" switch (item D), the timer must be preset to a value
of at least 1 minute. The maximum setting is 99 minutes.
The timer setting can be adjusted by pressing the respec-
tive timer buttons.
Press the button "1" (item E) to select units of minutes,
press the button "10" (item F) to select tens of minutes.
Before starting the centrifuge, close the cover:
Press the cover down manually until it clicks into place. The
cover should close easily.
Starting the centrifuge:
Start the centrifuge by pressing the "Start/ Stop" button
(item D).

Working with the unit

e.g.
e.g.
e.g.
15