Anti-Splinter Insert - Bosch JS120 Consignes De Fonctionnement/Sécurité

BM 2610033457 06-14_JS120 6/5/14 12:02 PM Page 9
ATTACHING NON-MARRING
OVERSHOE
Your tool is equipped with a protective plastic
overshoe that protects finer surfaces.
To attach, hook overshoe over front of metal
footplate and snap into place at rear of
footplate (Fig. 4).
FIG. 4
1
INSERTING AND RELEASING
BATTERY PACK
Release battery pack from tool by pressing
on both sides of the battery release tabs and
pull downward (Fig. 6).
To insert battery, align battery and slide
battery pack into tool until it locks into position.
Do not force.
If battery release tabs are
W RNING
cracked
damaged, do not insert into tool. Battery
can fall out during operation.
To minimize splintering of the top surface of
the material being cut, place the anti-splinter
insert in the blade opening of the footplate, or
the non-marring overshoe (Fig. 5).
Note: This insert will only work with blades
that have ground sides such as T301CD,
TB1B, T101D, and T101DP.
FIG. 5
NTI-SPLINTER
2
NON-M RRING
OVERSHOE
FIG. 6
or otherwise
-9-

ANTI-SPLINTER INSERT

INSERT
B TTERY
P CK
FOOTPL TE
RELE SE
T BS