Accessories - Bosch JS120 Consignes De Fonctionnement/Sécurité

BM 2610033457 06-14_JS120 6/5/14 12:02 PM Page 15
NO USER SERVICE-ABLE
W RNING
PARTS INSIDE. Preventive
maintenance performed by unauthorized
personnel may result in misplacing of
internal wires and components which
could cause serious hazard. We recom-
mend that all tool service be performed by a
Bosch Factory Service Center or Authorized
Bosch Service Station. SERVICEMEN:
Disconnect tool and/or charger from power
source before servicing.
BATTERIES
Be alert for battery packs that are nearing
their end of life. If you notice decreased
tool performance or significantly shorter
running time between charges then it is time
to replace the battery pack. Failure to do so
can cause the tool to operate improperly or
damage the charger.
TOOL LUBRICATION
Your Bosch tool has been properly lubricated
and is ready for use.
CARBON BRUSHES
The brushes and commutator in your tool
have been engineered for many hours of
dependable service. To maintain peak
efficiency of the motor, we recommend every
two to six months the brushes be examined.
Only genuine Bosch replacement brushes
specially designed for your tool should be
used.
BEARINGS
Bearings which become noisy (due to heavy
load or very abrasive material cutting) should
be replaced at once to avoid overheating or
motor failure.
W RNING
The use of any other accessories not specified in this manual may create a hazard.
* Non-marring overshoe
* Anti splinter insert
* T-shank jig saw blade
** Circle and parallel cutting guide
Maintenance
Service

Accessories

D.C. MOTORS
The motor in your tool has been engineered
for many hours of dependable service. To
maintain peak efficiency of the motor, we
recommend it be examined every six
months. Only a genuine Bosch replacement
motor specially designed for your tool should
be used.
Cleaning
To avoid accidents, always
W RNING
disconnect the tool and/or
charger from the power supply before
cleaning. The tool may be cleaned most
effectively with compressed dry air. Always
wear safety goggles when cleaning tools
with compressed air.
Ventilation openings and switch levers must
be kept clean and free of foreign matter. Do
not attempt to clean by inserting pointed
objects through opening.
Certain cleaning agents
C UTION
and
plastic parts. Some of these are: gasoline,
carbon tetrachloride, chlorinated cleaning
solvents, ammonia and household detergents
that contain ammonia.
CLEANING BLADE HOLDER
Clean the saw blade holder regularly. For this,
remove the saw blade from the tool and lightly
tap footplate on a level surface.
Regularly spray penetrating oil onto the saw
blade holder.
Check the guide roller regularly. If worn, it
must be replaced through an authorized
Bosch Factory Service Center
Lubricate the guide roller occasionally with a
drop of oil.
** Carrying case
** Other T-shank jig saw blades
(*= standard equipment)
(**= optional accessories)
-15-
solvents damage