Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ENGLISH
3. Move the slide, by sliding it until the holes
coincide with the slide locking screws (point 2).
4. Fasten the camera with the 1/4" screw. If
necessary, use the supplied spacers to correctly
position the camera and optics (point 3).
5. Reposition the internal slide by tightening the
previously loosened screws.
6. Close the housing after making the necessary
electrical connections.
Heater installation
This section describes how to install the heater
option in the housings not provided with. Heaters
can be supplied with working voltages of
12VDC/24VAC or 115/230VAC and include the
pre-wired heating element suitable for the working
voltage, metal dissipators and kit fastening screws.
1. Open the housing as described before.
2. Fix the heater kit to the prearranged points on
the body of the housing.
3. The pre-wired heating element should be
positioned between the two dissipators (Fig. 3)
before attachment to ensure contact and hence
guarantee correct heat diffusion.
4. Pass the heating wire under the fixing slide of
the camera.
5. Insert the two-pin connector at the end of the
cable into the correspondent support circuit
socket, identified by J3 HEATER (Fig. 9).
6. Reposition the internal support slide and close
the housing.
The circuit is also able to provide
the power supply for a camera.
While powering the circuit from
an external source, pay attention to the
type of working voltage and use the
correct power supply Kit, according to
requirements.
Camera power supply installation
N o t u s a b l e i n h o u s i n g s w i t h
wiper device installed.
This chapter describes how to install the camera
power supply option into the housing. There are
two types of camera power supply depending on
requirements.
One model has an input voltage from 100-
240VAC with an output voltage of 12VDC, 1A.
The other has an input voltage of 230VAC and an
output voltage of 24VAC, 400mA.
1. Open the housing as described before.
2. Using the screws supplied with the Kit,
assemble the power supply with the support
bracket (Fig. 4, point 5) and the corner
attachment bracket (Fig. 4, point 4), using the
points provided for this.
3. Insert the six-pin connector at the end of the
cable into the correspondent one on the
support circuit, identified by J7 (Fig. 9).
5. Close the housing.
When the circuit is powered by an
exter nal source care must be
taken to the type of voltage used
and, depending on requirements, to the
correct power supply kit. When installing
the optional camera power supply it is
not necessary to remove any previously
installed component.
Blower installation
N o t
u s a b l e
w i t h
c o o l i n g
wiper installed.
This chapter describes how to install the blower kit
option into the housings that are not equipped
with it. The blower kit can be supplied in three
different configurations depending on the power
supply voltage.
100-240VAC power supply:
1. Open the housing as described before.
2. Fix the blower inside the body of the housing,
using the corner bracket and screws supplied
(Fig. 6).
3. Insert the two pin connector at the end of the
cable into the corresponding one indicated by
J8 FAN on the support circuit (Fig. 9).
4. Install the camera power supply supplied with
9
Camera housing and accessories
i n
h o u s i n g s
d e v i c e
a n d
Publicité
Table des Matières
