CapsoVision CapsoCamPlus Mode D'emploi page 14

The CapsoCam Plus is intended for use in an electromagnetic environment in which radiated RF
disturbances are controlled. The customer or the user of the CapsoCam Plus can help prevent
electromagnetic interference by maintaining a minimum distance between portable and mobile RF
communications equipment (transmitters) and the CapsoCam Plus as recommended below, according to
the maximum output power of the communications equipment.
Rated Maximum output power
W
0.01
0.1
1
10
100
For transmitters rated at a maximum output power not listed above, the recommended separation distance (d)
in meters (m) can be estimated using the equation applicable to the frequency of the transmitter, where (P) is
the maximum output power rating of the transmitter in watts (W) according to the transmitter manufacturer.
NOTE 1 At 80 MHz and 800 MHz, the separation distance for the higher frequency range applies.
NOTE 2 These guidelines may not apply in all situations. Electromagnetic propagation is affected by absorption
and reflection from structures, objects and people.
14
Recommended separation distances between
portable and mobile RF communications equipment and the CapsoCam Plus
of transmitter
80 MHz to 800 MHz
d = 0.18√P
Document Number: IFU-2320 Rev: J Revision Date: 08/2020
(Table 4)
0.02
0.06
0.18
0.57
1.8
Separation distance according to frequency
of transmitter
m
800 MHz to 2.5 GHz
d = 0.35√P
0.04
0.11
0.35
1.1
3.5