CapsoVision CapsoCamPlus Mode D'emploi page 11

Guidance and manufacturer's declaration – electromagnetic emissions
The CapsoCam Plus is intended for use in the electromagnetic environment specified below.
The customer or the user of the CapsoCam Plus should assure that it is used in such an environment.
Emissions Test
RF emissions
CISPR 11
RF emissions
CISPR 11
Guidance and manufacturer's declaration – electromagnetic immunity
The CapsoCam Plus is intended for use in the electromagnetic environment specified below.
The customer or the user of the CapsoCam Plus should assure that it is used in such an environment.
Immunity Test IEC 60601 test level
Electrostatic
discharge (ESD) ±8 kV contact
IEC 61000-4-2 ±15 kV air
(50/60 Hz)
magnetic field
IEC 61000-4-8
Compliance
Group 1 The CapsoCam Plus uses RF energy only for its internal function.
Therefore, its RF emissions are very low and are not likely to cause
any interference in nearby electronic equipment.
Class B The CapsoCam Plus is suitable for use in all establishments,
including domestic establishments and those directly connected
to the public low voltage power supply network that supplies
buildings used for domestic purposes.
Compliance level
±8 kV contact
±15 kV air
30 A/m
Document Number: IFU-2320 Rev: J Revision Date: 08/2020
(Table 1)
Electromagnetic environment – guidance
(Table 2)
Electromagnetic environment – guidance
Floors should be wood, concrete or
ceramic tile. If floors are covered with
synthetic material, the relative humidity
should be at least 30 %.
30 A/m Power frequency magnetic fields
should be at levels characteristic of a
typical location in a typical domestic,
commercial or hospital environment.
11