Cable Specification - Lenze EMB9351-E Instructions De Mise En Service

7 Electrical installation

Cable specification

7.2 Cable specification
The cables used have to comply with the requirements on the location
ƒ
(e. g. EN 60204−1).
The corresponding minimum cross−sections of the cables have to be
ƒ
observed.
Only use shielded cables with a braid of tinned or nickel−plated copper.
ƒ
Shields of steel braid are unsuitable.
–
The overlap rate of the braid has to be at least 70 % with an overlap
angle of 90 °.
96
l
EDBMB935X DE/EN/FR 12.0