Lenze EMB9351-E Instructions De Mise En Service page 69

Mechanical installation
Install the product according to the regulations of the corresponding
ƒ
documentation. In particular observe the section "Operating conditions"
in the chapter "Technical data".
Provide for a careful handling and avoid mechanical overload. During
ƒ
handling neither bend components, nor change the insulation distances.
The product contains electrostatic sensitive devices which can easily be
ƒ
damaged by short circuit or static discharge (ESD). Thus, electronic
components and contacts must not be touched unless ESD measures are
taken beforehand.
Electrical installation
Carry out the electrical installation according to the relevant regulations
ƒ
(e. g. cable cross−sections, fusing, connection to the PE conductor).
Additional notes are included in the documentation.
When working on live products, observe the applicable national
ƒ
regulations for the prevention of accidents (e.g. BGV 3).
The documentation contains information about EMC−compliant
ƒ
installation (shielding, earthing, arrangement of filters and laying cables).
The system or machine manufacturer is responsible for compliance with
the limit values required by EMC legislation.
Warning: The controllers are products which can be used in category C2
drive systems as per EN 61800−3. These products may cause radio
interference in residential areas. If this happens, the operator may need to
take appropriate action.
For compliance with the limit values for radio interference emission at the
ƒ
site of installation, the components − if specified in the technical data −
have to be mounted in housings (e. g. control cabinets). The housings
have to enable an EMC−compliant installation. In particular observe that
for example control cabinet doors preferably have a circumferential
metallic connection to the housing. Reduce openings or cutouts through
the housing to a minimum.
Only plug in or remove pluggable terminals in the deenergised state!
ƒ
Commissioning
If required, you have to equip the system with additional monitoring and
ƒ
protective devices in accordance with the respective valid safety
regulations (e. g. law on technical equipment, regulations for the
prevention of accidents).
Safety functions
Without a higher−level safety system, the described product must neither
ƒ
be used for the protection of machines nor persons.
EDBMB935X DE/EN/FR 12.0
Safety instructions
General safety instructions
l
2
69