General Safety Warnings - Remington RM4040 Manuel De L'utilisateur

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

GENERAL SAFETY WARNINGS

Read the instructions carefully. Be familiar with the controls and
proper use of the unit. Know how to stop the unit and disengage
the controls quickly.
Stay alert. Do not operate this unit when tired, ill or under the
influence of alcohol, drugs or medication.
Never allow children to operate the unit. Teens must be trained,
accompanied and supervised by an adult. Never allow adults to
operate the unit without proper instruction.
All guards and safety attachments must be installed properly
before operating the unit.
Inspect the unit before use. Check for damaged parts. Make sure
all parts operate properly. Make sure all fasteners are in place
and secure. Make sure all moving parts are properly aligned and
are not bound. Replace parts that are cracked, chipped, or
damaged in any way. Have all damaged or improperly working
parts repaired or replaced by an authorized service center. Do
not operate the unit with loose or damaged parts.
Be aware of risk of injury to the head, hands and feet.
Carefully inspect the area before starting the unit. Remove
rocks, broken glass, nails, wire, string and other objects that
may be thrown or become entangled with the unit.
Clear the area of children, bystanders and pets; keep them
outside a 50-foot (15 m) radius, at a minimum. Even then, they are
still at risk from thrown objects. Encourage bystanders to wear
eye protection. If you are approached, stop the unit immediately.
This unit is intended for occasional, household use only.
Do not allow the unit to be used as a toy.
SAFETY WARNINGS FOR ELECTRIC UNITS
General Electric Safety
Do not expose the unit to rain or wet conditions. Store the unit
indoors.
Do not handle the unit with wet hands.
Avoid dangerous environments. Do not operate the unit in the
rain, in wet conditions or on wet surfaces. Moisture is a shock
hazard.
To reduce the risk of electric shock, avoid body contact with
grounded conductors, such as metal pipes or wire fences.
Do not operate the unit in explosive atmospheres, such as in the
presence of flammable liquids, gases or dust.
Battery Charger Safety
Follow all charging instructions. Do not charge the battery
outside the temperature range specified in these instructions.
Improperly charging the battery or charging the battery outside
of the specified temperature range may damage the battery and
increase the risk of fire.
A nameplate on the unit indicates the voltage used. Never
connect the unit to an AC voltage that differs from this voltage.
An extension cord should not be used unless absolutely
necessary. Use of an improper extension cord could result in a
risk of fire, electric shock or electrocution.
Do not use multiple extension cords.
Make sure the extension cord is heavy enough to carry the
current drawn by the unit. An undersized extension cord will
cause a drop in line voltage, resulting in a loss of power and
overheating. If in doubt, use the next heavier gauge cord. The
smaller the gauge number, the heavier the cord.
MINIMUM WIRE SIZE FOR EXTENSION CORDS FOR
120 VOLT APPLIANCES USING 0-6 AMPS
Cord Length (ft.)
Wire Size (AWG)
Make sure the cords are in good condition. Inspect the power
cord and extension cord periodically. Look closely for
deterioration, cuts or cracks in the insulation. If a cord is
damaged in any manner while plugged in, disconnect the cord
from both the outlet and the unit. Do not use a damaged cord.
Damaged cords should be repaired or replaced.
Do not abuse cords. Never pull or carry the unit by a cord. Keep
cords away from heat, oil, water, sharp edges, and moving
objects. Always grasp the plug when disconnecting a cord.
Never modify a plug, cord or outlet in any way.
Ground Fault Circuit Interrupter (GFCI) protection should be
provided on the circuit(s) or outlet(s) to be used with this unit.
For an extra measure of safety, use receptacles with built-in
GFCI protection.
Do not place the battery charger where cords might be stepped
on, tripped over or subjected to damage.
Do not charge batteries in the rain or in wet conditions. Keep the
battery charger in a cool and dry area.
Keep the battery charger away from all liquid.
Do not allow small metal items or material such as steel wool,
aluminum foil or other foreign particles into the charger port.
Do not probe the charger with conductive material. There is a
risk of electric shock.
Do not cover the battery charger. The battery charger may
overheat.
Do not allow the battery or battery charger to overheat. If they
are warm, allow them to cool down. Only charge batteries in
temperatures between 32° and 104° F (0° and 40° C).
Always unplug the battery charger before cleaning it. Always
unplug the battery charger when it is not in use.
Battery Safety
Do not expose the battery to fire or to temperatures over 176º F
(80º C). Doing so could cause an explosion.
Handle batteries with care. Do not short the battery with
conductive materials, such as rings, bracelets, keys, etc.
Shorting the battery may cause personal injury, damage to the
battery or a fire.
When the battery is not in use, keep it away from small metal
objects, such as paper clips, coins, nails, etc. These items could
connect one terminal to another and short the battery.
Do not attempt to charge a cracked or damaged battery.
Do not use a damaged or modified battery. Doing so could result
in a fire, explosion or personal injury.
WARNING:
fire or chemical burn if mistreated. Do not disassemble,
overheat or incinerate the battery. The battery may develop a
small leak under extreme usage or temperature conditions.
If battery fluid contacts skin:
- Immediately wash the area with soap and water.
- Neutralize the battery fluid with a mild acid (lemon
juice, vinegar, etc.).
- Seek immediate medical attention.
If battery fluid gets in the eyes:
- Immediately flush the eyes with clean water for at
least 15 minutes.
- Seek immediate medical attention.
5
25
50
100
150
16
16
16
The battery may present a risk of
14

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Rm4040b

Table des Matières