Troubleshooting - Remington RM4040 Manuel De L'utilisateur

PROBLEM
THE BATTERY WILL NOT CHARGE
The battery charger is not plugged in
The battery is not fully inserted into the battery charger
The battery and/or charger are too hot or too cold
The battery and/or battery charger are no longer functional
THE BATTERY DIES QUICKLY
The battery is not fully charged
The battery and/or battery charger are no longer functional
THE MOTOR WILL NOT RUN
The battery lacks sufficient charge
The battery is not installed correctly
The trigger lockout was not engaged
THE MOTOR STOPS WHILE IN USE, BUT THE BATTERY STILL HAS SUFFICIENT CHARGE
Device protection systems have engaged
THE SAW CHAIN COMES OFF THE GUIDE BAR
The saw chain tension is too loose
The guide bar and saw chain are assembled incorrectly
THE GUIDE BAR AND SAW CHAIN ARE RUNNING HOT, SMOKING OR STUCK
The saw chain tension is too tight
The saw chain and guide bar lack sufficient oil
The guide bar groove and oil passages are dirty
THE SAW CHAIN DOES NOT ROTATE
The saw chain tension is too tight
The guide bar and saw chain are assembled incorrectly
The guide bar and saw chain are damaged
The drive assembly is damaged
THE SAW CHAIN ROTATES, BUT DOES NOT CUT
The saw chain is dull
The saw chain is on backwards

TROUBLESHOOTING

If further assistance is required, contact an authorized service center.
SOLUTION
Plug the battery charger into a 120V 60hz AC source
Remove and then reinsert the battery into the battery charger
completely
Make sure the battery and charger are in an environment between
32° and 104° F (0° and 40° C). Allow time for the battery and/or
charger to warm up or cool down.
Refer to the Warranty section for replacement information
Charge the battery completely
Refer to the Warranty section for replacement information
Charge the battery completely
Remove and reinstall the battery
Press and hold the trigger lockout before squeezing the trigger
Remove the battery, allow it to cool for 30 seconds, then reinstall
the battery
Adjust the saw chain tension
Refer to Removing and Installing the Guide Bar and Saw Chain
Adjust the saw chain tension
Fill the chain oil reservoir
Clean the guide bar and oil passages
Adjust the saw chain tension
Refer to Removing and Installing the Guide Bar and Saw Chain
Inspect the guide bar and saw chain for damage. Replace them if
necessary
Refer to Service information
Sharpen or replace the saw chain
Check and correct the saw chain direction
28