Clean-Out Tunnel - Williams EvoJet Serie Mode D'emploi

Clean-out Tunnel Instructions
WARNING.
within the pump tunnel can cause
severe injury. Ensure both the engine and
battery isolators are turned off prior to
opening.
2 Move the aft folding seat into the open
position.
4 Rotate the handle ANTI-CLOCKWISE until
the end of travel.
6 Pull handle upwards to remove plug from
the tunnel opening.
20
The rotating drive shaft
TO OPEN CLEAN-OUT TUNNEL
1 Stop the engine and set the battery isolator
switch to "OFF". Remove keys from ignition.
3 Unlock and open the latches to release the
access panel.
5 Move the locking bar marked (A) clear of
the tunnel opening.
7 The pump tunnel may now be accessed.