Checking The Oil Level; Warning Lights - Williams EvoJet Serie Mode D'emploi

Checking the Oil Level

Wait 10 minutes after engine has stopped
to accurately check oil level.
•
The oil level should be between the
Minimum and Maximum lines on the
dipstick (right).
•
Use only the recommended grade of oil
(SAE 10W30 or SAE 15W40). Refer to
Yanmar Engine Operator's Manual.
•
Do not overfill.
CAUTION. Use of different oil to the
specified type may cause seizure or
early wear to inner parts, leading to shortening
of the engine's service life.
Loading
WARNING. When loading the craft,
never exceed the maximum
recommended load. Always load the craft

Warning Lights

CAUTION. Risk of engine damage.
In the event that a warning lamp or
buzzer activates during use, STOP engine
Fire Extinguisher
The fire extinguisher within the engine bay
operates automatically. It can also be activated
manually in the event of a fire by opening the
main helm panel, removing the safety pin and
then pulling the handle towards you.
1 Full 2 Add oil
3 Operating range
3
2
The dipstick has two lines, the top being the
upper limit and the bottom being the lower
limit.
carefully and distribute loads appropriately to
maintain design trim (approximately level).
Avoid placing heavy weights high up.
immediately, investigate the cause and/or
contact your authorised Williams Dealer.
Inspect system pressure regularly; refer to the
extinguisher label for Pressure/Temperature
Table. In some conditions the extinguisher
may require resetting; this is done by pressing
the extinguisher reset button found on the
extinguisher display unit. Refer to Engine Bay
pictures for the extinguisher's location.
1
15