General Specifications, Engine; Engine Specifications - Williams EvoJet Serie Mode D'emploi

After beaching, move the boat into deeper
water and rock from side to side several times
to remove sand from the intake area. Failure to
do so could cause damage to the jet unit.
General Specifications
Draught (fully loaded)
Yanmar Engine
* Dimensions may vary as the inflatable tubes are hand made.
boat trim and loading.

Engine Specifications

Please refer to the Yanmar Engine Operator's manual for all engine-related information.
Classification
Category C: This craft is designed to
operate in winds up to Beaufort force 6 and
associated wave heights (significant wave
height up to 2 m, see note below). Such
conditions may be encountered in exposed
inland waters, in estuaries and in coastal
waters in moderate weather conditions.
This boat complies with ISO 6185-3. The
CE plate is located in the starboard rear
footwell. The CE plate is the certification to
European Directive 94/25/CE. This boat is
also compliant with US Coastguard and ABYC
regulations.
10
EvoJet
7.1 m
Length (OA)*
2.65 m
Beam (OA)*
2.64 m
Height (OA)
0.52 m
2000 kg
Dry weight
4LV 250 hp
40 mph/65 kph
Top speed
‡
See Loading section on page 15.
TRIM
CAUTION. Do not overload the boat.
At all speeds be aware of trim and keep
weight evenly distributed.
Fuel
Fuel capacity
Seating capacity
Maximum load capacity
Tube compartments
Design category (CE)
†
Not all fuel tank capacity may be available, due to
NOTE The significant wave height is the mean
height of the highest one-third of the waves,
which approximately corresponds to the wave
height estimated by an experienced observer.
Some waves will be double this height.
EvoJet
Diesel
†
200 litres
13
‡ 1105 kg
5
C