Operating Elements And Displays; Operating Panels And Displays; Signal Tones; Overheating Protection Facility - CASO DESIGN Master P3 Plus Mode D'emploi Original

14.2 Operating elements and displays

14.2.1

Operating panels and Displays

1. Master On/Standby switch
2. On/Standby switch for each hob
3. Indicator lamp power stage for each hob
4. Indicator lamp temperature for each hob
5. Indicator lamp time for each hob
6. Selection button for power stage, temperature, timer
7. Selection button (-), reduction of the power stage, temperature or duration
8. Selection button (+), increase of the power stage, temperature or duration
9. LED display for each hob
10. Lock
The induction cooker has three hobs which can be used separately. Therefore you
have three operating panels.
The display is used to show the selected temperature, power level, timer and to show the
error code in the event of a malfunction.
14.2.2

Signal Tones

The appliance emits an acoustic signal after being switched on and in the event of a fault.
14.2.3

Overheating Protection Facility

The appliance is equipped with an overheating protection facility. If the temperature of the
appliance exceeds the critical limit the appropriate error message „E05"" is displayed. For
safety reasons the appliance shuts off further power supply. After the cooling-down phase
the appliance can be switched off and then back on again.
► You will find more detailed information on error messages in the chapter entitled
„Fault indications".
caso Master P3 Plus
Please note
41