Operating Elements And Displays; Signal Tones; Overheating Protection Facility; Automatic Shutdown Protection - CASO DESIGN Pro Slide 2100 Mode D'emploi Original

13.2 Operating elements and displays

1. Master On/Standby switch
3. Selection button for timer
5. Special function, above: Keep Warm, beneath: Frying
6. Slide Control for power stages
13.2.1

Signal Tones

The appliance emits an acoustic signal after being switched on and in the event of a fault.
13.2.2

Overheating Protection Facility

The appliance is equipped with an overheating protection facility. If the temperature of the
appliance exceeds the critical limit the appropriate error message is displayed and an
acoustic signal sounds. For safety reasons the appliance shuts off further power supply.
After the cooling-down phase the appliance can be switched on again.
► Do not place any empty cookware on the cooking area. Heating an empty pot or pan
activates the overheating protection and the device turns off automatically.
13.2.3

Automatic shutdown protection

The device is equipped with an auto shut down safety protection function. If ever you forgot
to turn off your hotplate, it shuts down automatically.
Power level
1~12
13.2.4

Rating plate

The rating plate with the connection and performance data can be founded on the back of
the device.

14 Operation and Handing

This chapter provides you with important notices with regard to operating the device.
Observe the following notices to avoid dangers and damages:
Warning
► Do not leave the device unsupervised when it is in operation, so that you can intervene
quickly in the event of dangers.
2. Selection button for power stage and timer (+/-)
4. Booster
automatic shutdown after
2 hours
42