Possible Wall Stud Configurations; Locate Wall Stud(S) - Whirlpool YJMV9196CS Instructions D'utilisation

NOTE: If no wall studs exist within the cabinet opening, do not
install the microwave oven.
See illustrations in "Possible Wall Stud Configurations."

Possible Wall Stud Configurations

These depictions show examples of preferred installation configurations with the mounting plate.
No Wall Studs at End Holes
B
C
A
E
F
Wall Stud at One End Hole
B
A
E
C
F
8

Locate Wall Stud(s)

Figure 1
Figure 3
A. End holes (on mounting plate)
B. Cabinet opening vertical centerline
C. Wall stud centerlines
D. Holes for lag screws
E. Support tabs
F. Mounting plate center markers
1. Using a stud finder, locate the edges of the wall stud(s)
within the opening.
2. Mark the center of each stud, and draw a plumb line down
each stud center. See illustrations in the "Possible Wall Stud
Configurations."
No Wall Studs at End Holes
B
C
D
A
A
E
F
E
NOTE: If wall stud is within 6" (15.2 cm) of the vertical centerline
(see the "Mark Rear Wall" section), only recirculation or roof
venting installation can be done.
Wall Studs at Both End Holes
B
D
A,D
A,D
E
E
C
C
F
Figure 2
Figure 4
C
D
A
E
A,D
E
C