Install The Microwave Oven - Whirlpool YJMV9196CS Instructions D'utilisation

WARNING
Excessive Weight Hazard
Use two or more people to move and install
microwave oven.
Failure to do so can result in back or other injury.
IMPORTANT: The control side of the microwave oven is the
heavy side. Handle the microwave oven gently.
1. Remove the 2 packing spacers from the top of the vent grille
before using the microwave oven.
A
A. Packing spacers (2)
NOTE: Depending on your model, it may not have packing
spacers. If it does not have packing spacers, begin with step 2.
2. Place a washer on each 1/4-20 x 3" flat-head bolt and place
inside upper cabinet near the 3/8" (10 mm) holes.
3. Make sure the microwave oven door is closed and taped
shut.
4. Using 2 or more people, lift microwave oven and hang it on
support tabs at the bottom of mounting plate.
NOTE: To avoid damage to the microwave oven, do not grip or
use the door or door handle while the microwave oven is being
handled.
A. Mounting plate
B. Support tabs
12

Install the Microwave Oven

5. With front of microwave oven still tilted, thread power supply
6. Rotate microwave oven up toward upper cabinet.
NOTE: If venting through the wall, make sure the damper
assembly fits easily into the vent in the wall cutout.
7. Push microwave oven against mounting plate and hold in
NOTE: If microwave oven does not need to be adjusted, skip
steps 7 through 9.
8. If adjustment is required, rotate microwave oven downward.
9. Loosen mounting plate screws. Adjust mounting plate and
10. Repeat steps 3 through 6.
11. With the microwave oven centered, and with at least one
NOTES:
A
B
cord through the power supply cord hole in the bottom of the
upper cabinet.
place.
Using 2 or more people, lift microwave oven off of mounting
plate, and set aside on a covered surface.
retighten screws.
person holding it in place, insert bolts through upper cabinet
into microwave oven. Tighten bolts until there is no gap
between upper cabinet and microwave oven.
Some upper cabinets may require bolts longer or shorter
■
than 3" (7.6 cm). Longer or shorter bolts are available at
most hardware stores.
Overtightening bolts may warp the top of the microwave
■
oven. To avoid warping, wood filler blocks (installer to
provide) may be added. The blocks must be the same
thickness as the space between the upper cabinet
bottom and the microwave oven.
A
A. Bolts
A. Bolts