Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Remove Cardboard Template
The cardboard piece from the top of the microwave oven
packaging is perforated. The piece inside the perforation is for
use as a rear wall template.
1. Cut along the perforation to separate the template from the
rest of the cardboard packaging.
2. Set the cardboard template to the side and refer to it during
the "Mark Rear Wall" part of installation.
Depending on your model, skip "Remove Cardboard Template"
steps if full carton box is used for packing. But use the wall
template for "Mark Rear Wall" part of the installation.
Location Requirements
Check the opening where the microwave oven will be installed.
The location must provide:
Minimum installation dimensions. See the "Installation
■
Dimensions" illustration.
Minimum one 2" x 4" (50.8 x 101.6 mm) wood wall stud and
■
minimum 3/8" (1 cm) thickness drywall or plaster/lath within
cabinet opening.
Support for weight of 150 lbs (68 kg) which includes
■
microwave oven and items placed inside the microwave
oven and upper cabinet.
Grounded electrical outlet inside upper cabinet. See the
■
"Electrical Requirements" section.
NOTES:
If installing the microwave oven near a left sidewall, make
■
sure there is at least 6" (15.2 cm) of clearance between the
wall and the microwave oven so that the door can open fully.
Some models have a pocket handle. If installing the
■
microwave near a right side wall, make sure there is at least
3 inches of clearance between wall and microwave oven so
you can grab the handle integrated inside the door.
Some cabinet and building materials are not designed to
■
withstand the heat produced by the microwave oven for
cooking. Check with your builder or cabinet supplier to make
sure that the materials used will not discolor, delaminate, or
sustain other damages.
Special Requirements
For Wall Venting Installation Only:
Cutout must be free of any obstructions so that the vent fit
■
properly and the damper blade opens freely and fully.
For Roof Venting Installation Only:
If you are using a rectangular-to-round transition piece, the
■
3" (7.6 cm) clearance needs to exist above the microwave
oven so that the damper blade can open freely and fully.
See "Rectangular to Round Transition" illustration in the
"Venting Design Specifications" section.
Installation Dimensions
NOTE: The grounded 3 prong outlet must be inside the upper
cabinet. See the "Electrical Requirements" section.
(76.2 cm)
66" (167.6 cm) min.
A. 2" x 4" (5.1 x 10.2 cm) wall stud
B. Grounded 3 prong outlet
*30" (76.2 cm) is typical for 66" (167.6 cm) installation height.
Exact dimensions may vary depending on type of range/cooktop
below.
NOTE: To ensure good performance, do not obstruct top vent
airflow. If cabinets are deeper than 14" (35.6 cm) but no more
than 15" (38.1 cm), use the bump out mounting kit replacing the
I bar mounting plate from the wall. The bump out mounting kit
(part # W11185746) is not provided but can be purchased from
Whirlpool.
12" DEEPER 14"
I bar mounting plate
Product Dimensions
*Overall depth of product will vary slightly depending on door
design.
A
B
12" (30.5 cm) min.
14" (35.6 cm) max.
upper cabinet and
30"
side cabinet depth
min.
30"
(76.2 cm)
typical*
14" DEEPER 15"
Bump out mounting bracket
3
Publicité
Table des Matières
