Smcb-Display Parameter List - Kübler SMCB Instructions D'utilisation

6. SMCB-Display Parameter List

The parameter list of the safety units can be found in the respective operation
manual.
If the SMCB-Display is connected to a PC which is equipped with the OS6.x
operator surface, the parameters (see below) are listed on the left side of the
program.
If the SMCB-Display is connected to a safety unit (please observe the DIL-
switch settings), the parameters (see below) are listed in the following menu:
Display Unit
Parameter Group
Input Scaling *)
Unit Settings
Serial Settings
*) If the version of the safety device is lower than 04A, scaling parameters are in SMCB-Display. When the safety
device version is higher than 04A, scaling parameters are in the "OPU Menu" of the safety device.
Doc. # R60718
 Edit Data ...
Parameter
X Factor 1
/ Divisor 1
+/- Value 1
Units 1
Decimal Point 1
X Factor 2
/ Divisor 2
+/- Value 2
Units 2
Decimal Point 2
Display Mode
Screen Light
Screen Saver
PIN Value
Touch Tones
Unit Number
Serial Baud
Rate
Serial Format
SMCB-Display Parameter List
Min
1 999999
1 999999
-999999 999999
0
0
1 999999
1 999999
-999999 999999
0
0
1
0
0
0 9999
0
11
0
0
Max Default
1
1
0
12 0
5 0
1
1
0
12 0
5 0
3 1
99 0
999 1
0
1 1
99 11
10 0
9 0
EN - 20