Edit Parameter - Kübler SMCB Instructions D'utilisation

5.5. Edit Parameter

The „Edit Data"- menu can be found as follows:
Safety Unit
Display Unit
After choosing the device to be edited in the first menu level, which is followed
by the selection of „Edit Data", the selectable parameter-groups are shown. All
respective parameters are listed here (see chapter 6).
After changing parameters these must be saved.
This is important to ensure, that the changes took effect also after power-off or
when the SMCB-Display has been removed from the safety unit (see chapter
0).
Parameter changes of the safety unit are only effective after
saving (see 5.6.1).
Doc. # R60718

Load Data From ...
 Edit Data ...
The selection menu of the parameter-group can be
reached in the menu option „Edit Data". After
confirmation by pressing OK, the respective
parameter-groups are shown in the display.
Please select the parameter to edit by using the
arrow buttons. The actual value of the parameter is
also shown display. After pressing OK, the
parameter can be edited.
By using the arrow buttons left/right, the cursor can
be skipped to another position (the relevant number
flashes). By using the arrow buttons up/down, the
value can be changed. Press OK to confirm or C to
leave the entry.
Electrical Connections

Edit Data ...
EN - 16