Unit Mode „Normal Operation; Display 1: Frequencies (Hz); Display 2: Divergence (%); Display 3: Scaled Input 1 - Kübler SMCB Instructions D'utilisation

5.1. Unit Mode „NORMAL OPERATION"
The DIL-switch positions of the safety unit are:
By using the arrow buttons, this mode allows to change the displays of the
SMCB-Display as follows:

5.1.1. Display 1: Frequencies (Hz)

5.1.2. Display 2: Divergence (%)

5.1.3. Display 3: Scaled Input 1

Doc. # R60718
Both input frequencies of sensor1 and sensor2 are
indicated with one decimal place (see "Operational
Mode" of the safety unit).
The indication is independent from the safety device
scaling.
Indicates the divergence of both input frequencies in
percent (see "Div. Calculation" of the safety unit).
The indication depends on parameters of the
Sensor Menus and divergence parameters settings
of the safety device.
In this display, the respective input frequency of
sensor1 is converted according to its adjusted
parameters („OPU-Menu" in safety device) and
shown in the display. *) See chapter 6.1
Electrical Connections
EN - 9