Save Parameter; Save Parameter To Safety Unit; Save Parameter To Display Unit; Storage Hints - Kübler SMCB Instructions D'utilisation

5.6. Save Parameter

The „Save Data To..."- menu can be found as follows:
Safety Unit
Display Unit

5.6.1. Save Parameter to Safety Unit

The following storage locations are selectable for the safety unit parameters:

5.6.2. Save Parameter to Display Unit

5.6.3. Storage Hints

Doc. # R60718

Load Data From ...
 Edit Data / Save Data ...
Select „Save Data To Safety Unit" to save the
respective parameters in that unit. Then press OK to
confirm.
Select „Save Data To Flash Memory" to save
parameters of the safety unit into the flash memory
of the SMCB-Display. Then press OK to confirm.
To save parameters in the SMCB-Display, please
select
„Save Data To Display Unit" and press OK to
confirm.
To ensure a correct storage, the procedure must be
confirmed with OK. The respective storage location
is shown in the info line of the display.
Electrical Connections

Edit Data / Save Data ...
EN - 17