Modus „Factory Settings - Kübler SMCB Instructions D'utilisation

5.2. Modus „FACTORY SETTINGS"
The DIL-switch positions of the safety unit are:
The programming unit SMCB-Display cannot be set to default values!
In order to keep the actual parameter settings safety, these
can be stored in the flash memory of the SMCB-Display
unit. At first the parameters must be transmitted from the
safety unit into the SMCB-Display (see chapter 0). Then
the parameters can be stored (see chapter 0).
Doc. # R60718
This mode is used to reset the safety unit back to its
default values with the next power-up. No data entry
at the SMCB-Display is possible here!
Electrical Connections
EN - 11